zgemma setup guide

zgemma setup guide

Citation preview

Quick Start and Full User Guide 30th November 2016 - Onwards ----------------------------------------------------------------------------------------------------------------

Table of Contents 1.    

Installation of Box How to Setup from out the box Quick Start Guide Setup Local TV Region Change Position of screen

2

2.    

Install a HDD/USB for storage Format a HDD/USB Initialize your drive Setup a Swap File Check location for recording/timeshift/EPG

5

3. Add IPTV Subscription

7

4. Record and Series Link

8

5. Your New Remote  Key to your new remote control

9

1 of 11

How to Setup from out the box

Remove from your box; mains adapter and cable, remote control (2xAAA batteries required), HDMI cable and ZGemma.

TIP Make sure to remove all plastic shrink-wrap from ZGemma before powering on! Leaving on the shrink-wrap may cause the box to overheat due to air vents being covered. First connect your two existing satellite coax cables into the back of the box (like below). Ensure there tightly connected. Note: If your only using one satellite co ax cable it must go into 'TUNER A IN' (bottom right port) If your using a second then it must go into LNB IN (top port)

Connect your internet cable (not included) either directly from your router or via home plugs into the back of the box

2 of 11

THIS CONNECTION IS IMPORTANT - YOU MUST HAVE YOUR BOX CONNECTED TO YOUR ROUTER FOR THE BOX TO WORK Connect the HDMI cable from TV to box Plug in the power lead to 'DC IN' Press in the white 'ON/OFF' power button to boot up box. Front LED screen should say boot then load up to 100

Quick Start Guide IF YOUR USING ONLY ONE SATELLITE CABLE: Navigate to Menu > Setup > Service Searching > Tuner configuration > Tuner A must be set to single & Tuner B must be set to 'not configured' > press back then NO on the next pop up. IF YOUR USING TWO SATELLITE CABLES: Navigate to Menu > Setup > Service Searching > Tuner configuration > Tuner A must be set to single & Tuner B must be set to 'SINGLE' to match Tuner A > press back then NO on the next pop up. Menu - Setup - Service Searching > Sky Bouquets Maker > Menu > BBC/ITV Region: Change Region to your local TV Region > Choose whether you want 'Child Safe' Channel lists > Green Button to save > Green Button to Scan If you have a USB/HDD pre installed in the box, please proceed. If you do not have any USB/HDD installed then please follow the guide. This is highly reccommended. Once completed the scan, go to: Menu > Setup > CrossEPG > Download Now Complete.

3 of 11

If you need to change the screen positioning due to some of the screen missing please follow: Red Button > 7 (Quick Start Setup) > 1 (OSD Position) • Highlight the Move Left/Right line and press the LEFT or RIGHT buttons until the left side of the RED box is visible, then press the LEFT button until the left side of the RED box is NOT visible • Highlight the Width line and press the LEFT or RIGHT buttons until the right side of the RED box is visible, then press the RIGHT button until the right side of the RED box is NOT visible • Highlight the Move Up/Down line and press the LEFT or RIGHT buttons until the top side of the RED box is visible, then press the LEFT button until the left side of the RED box is NOT visible • Highlight the Height line and press the LEFT or RIGHT buttons until the right side of the RED box is visible, then press the RIGHT button until the right side of the RED box is NOT visible

Install a HDD/USB for storage >>>>> If you have a USB/HDD Pre installed in the back of your box you do NOT need to follow these instructions Select the IPTV channel you wish to watch.

NOTE If no IPTV Bouquet is created, this is due to the M3U file provided being invalid – Check with your IPTV provider.

6 of 11

Rec